Administration > Monitor Administration > SiteScope Data Collector Configuration > Managing SiteScope > SiteScope Preferences > SNMP Trap Preferences > Configuring SNMP Trap Preferences Properties
Configuring SNMP Trap Preferences Properties
Use the following steps to configure the default SNMP Trap Preferences properties.
To configure SNMP Trap Preferences properties:
- Click on the Preferences container in the left menu tree. The Preferences container contents is displayed.
- Click on the SNMP Trap Preferences link under the applicable container in the right hand panel. If necessary, click on the Properties tab in the upper right hand corner of the right hand panel to display the SNMP Trap Preferences Properties panel.
- Click the Edit button at the bottom of the Properties panel. The Edit SNMP Trap Preferences page is displayed in the content panel.Alternately, you can right-click the SNMP Trap Preferences container in the left menu tree to display the container action menu and select Edit Defaults.
- Complete the items in the Main Settings section as described below.
- When the required settings are defined, click OK to save the SNMP Trap Preferences settings.
Main Settings
You use the Main Settings section of the SNMP Trap Preferences Properties page to preference object action SNMP Trap Preferences settings. Complete the items for the SNMP Trap Preferences Properties as described below.
Send to Host
Enter the domain name or IP address of the machine that will receive all SNMP trap messages. This is machine must be running a SNMP console in order to receive the trap message. Examples of valid names are snmp.mydomain.com or 206.168.191.20.
SNMP Community
The default SNMP community name used for sending traps. The default community by most systems is public. The community string must match the community string used by the SNMP management console.
SNMP Trap Version
Select the default SNMP protocol version number to use. SNMP v1 and v2c are currently supported.
SNMP Trap ID
The type of trap to send. There are several predefined ID types for common conditions. You use the Generic SNMP Trap ID drop-down menu to select a generic SNMP type. To use an enterprise specific SNMP ID type, select the Other option in the Generic SNMP Trap ID drop-down menu and then enter the number of the specific trap type in the Enterprise-Specific SNMP Trap ID field.
SNMP Object ID
This identifies to the console the object that sent the message. There are several predefined objects to select from in the list. To use another OID, select Other... from this list and enter the other OID in the Other SNMP Object ID text box.
Other SNMP Object ID
Use this entry to specify an object ID other than those in the SNMP Object ID selection box. You must select Other... in the SNMP Object ID selection to enable this option.
| Copyright 2006 Mercury Interactive Corporation |