Administration > Monitor Administration > SiteScope Data Collector Configuration > Managing SiteScope > SiteScope Preferences > SiteScope General Preferences > Suspending Monitor Processes
Suspending Monitor Processes
In large and complex monitoring environments, it is possible that SiteScope can become heavily loaded with a large number of monitors running and the responsiveness may become slow. This may be due to some monitors being configured to monitor too aggressively or systems that are becoming overloaded. If monitoring actions are slowing the performance of SiteScope, it can be useful to temporarily suspend monitoring actions in order to make configuration changes. You can temporarily suspend monitors to reduce the time required to complete large configuration operations such as a global search and replace operation using Monitor Administration. The Suspend Monitors option provides this function.
Suspend Monitors
Check this box to temporarily suspend the execution of all monitors. You can suspend all monitors temporarily, make configuration changes, and then resume monitoring again by clearing this option and save change.
Note: This option has the effect of disabling all monitors currently defined for this SiteScope installation. It is, however, not the same as a Disable all monitors action. If you set Suspend Monitors and then later clear this box to re-enable the monitors, those individual monitors that were set as disabled prior to the Suspend Monitors action will retain their original disabled state. This is different from a global disable action. If you were to select all monitors and Disable them (using the Manage Monitors and Groups page) and later re-enable them, the Disable state would be set and then cleared for all monitors, regardless of their state prior to the action.
Note: Using this option may impact reports. Monitors that would have run during the time that monitoring was suspended may display blanks for that period in reports.
Warning: There is currently no visual indication in the interface that a SiteScope is in a suspended monitor state. When the Suspend Monitors option is enabled, the following message is displayed in the corresponding SiteScope:
SiteScope is in Suspended mode; no monitors are currently running.
To reactivate monitoring, clear the Suspend Monitors setting on the General Preferences page.
| Copyright 2006 Mercury Interactive Corporation |