R E L E A S E N O T E S Broadcom NetXtreme Network Interface Card Extended Information SNMP Extensible-Agent for Windows NT, 2000, XP SNMP Service Version 1.05 Copyright(c) 2003 Broadcom Corporation All Rights Reserved. Feb 20, 2003 ******************************************************************************* Overview -------- The Broadcom NetXtreme Adapter Extended Information SNMP extensible-agent, bcmif.dll is designed for Windows 2000 and Windows NT SNMP Service. It is required to install the Windows NT/Windows 2000 SNMP service before installing the extensible-agent. The extensible-agent allows the SNMP manager software to actively monitor the configurations of the Broadcom NetXtreme Network Interface Card. It is intended to supplement the information already provided by the standard SNMP Management Network Interface information. The extensible-agent provides in-depth information about a Broadcom NetXtreme adapter such as: its MAC address, its bound IP address, IP subnet mask, physical link status, adapter state, line speed, duplex mode, memory range, interrupt setting, bus number, device number, function number To monitor these information, a SNMP manager needs to load the Broadcom Extended information MIB file to allow monitoring of the information described above. This file, bcmif.mib, is included with the Broadcom NetXtreme adapter installation CD. The monitored workstation requires the installation of the Broadcom Extended Information SNMP extensible-agent, bcmif.dll, and requires the Microsoft Windows 2000 or Windows NT 4.0 SNMP service to be installed and loaded. Installation of this component will be described in following sections. Manual Installation ------------------- (1) Make sure Microsoft SNMP Service is installed. (2) Use registry editor to add following keys: (a) Go to "HKLM\System\CurrentControlSet\Services\SNMP\Parameters\ExtensionAgent" sub-key. (b) Locate the highest number shown under this sub-tree and create a new string value with the name as one plus the highest number, e.g. if the highest number shown is 5, create a DWORD value key with name "6" and the value as "SOFTWARE\Broadcom\Bcmif\CurrentVersion". (c) Go to "HKLM\Software". (d) Create three sub-keys underneath this tree as "Broadcom\Bcmif\CurrentVersion". (e) Go to "HKLM\Software\Broadcom\Bcmif\CurrentVersion". (f) Create a STRING key with the name "pathname" and the value as "%systemroot%\system32\bcmif.dll" (3) Open a command prompt and enter "net stop SNMP" to stop the the current running instance of the SNMP service. (4) Enter "net start snmp" to restart the SNMP service.