DESCRIPTION
    Resume the LAST opatchauto session. It will continue from the failed
    command of the LAST session. You can also resume a failed 'resume' 
    session and it will continue from wherever the previous session failed.


SYNTAX
    opatchauto resume

This command does not recognize or accept any additional command-line options.
The older versions of opatchauto accepted parameters such as '-oh', '-reboot',
'-jre' and '-invPtrLoc' but this version does not take into consideration any 
such parameters for this command.

ADDITIONAL INFORMATION

1. 'opatchauto resume' command can be used to resume any failed opatchauto 
   session, whenever the opatchauto log summarizes it as an option to
   the user.
2. The 'opatchauto resume' command will try to resume the LAST opatchauto
   session run on the same node, without considering the home from which it 
   might have been started. It does not take into consideration the oracle home
   from which the 'resume' session is being started.
3. The user always has the choice of either starting a new opatchauto session
   OR 
   resuming the failed session after fixing the cause of failure.
4. Before starting a 'resume' session the user must ensure the stack is
   at the same state as it was when the last opatchauto session had failed. 

Depending on the status of the last run opatchauto session, the behavior of
the 'opatchauto resume' session can be summarized as follows:
1. If the last 'opatchauto' session had failed, 'opatchauto resume' will
   try to resume from the failed command and execute all the pending
   steps/commands in that failed session.
2. If the last session happens to be a failed 'resume' session,
   'opatchauto resume' will try to continue from wherever the previous 'resume'
   session failed.
3. If the last session was successful, 'opatchauto resume' would be a void 
   session.

